Configuring batch synchronization
The Enable periodic invocation of batch sync
setup option in the Batch Sync Setup tab
lets you configure a recurring batch job to set up synchronization for users
in bulk.This option is disabled by default.
- In NexJ Admin Console, navigate to the Synchronization page.
- Select a server in the Targets list of the Synchronization tab.
-
Click Configure in the Global
Options field in the pane on the right side of the
page.
The Global Exchange Synchronization Options dialog opens.Note: These options are global and apply to all Exchange servers configured for synchronization with NexJ CRM.
-
Click the Batch Sync Setup tab and
configure any of the following parameters:
- Enable periodic invocation of batch sync setup
- Enables batch sync setup. For more information, see Periodic configuration of prospects.
- Default: Disabled
- Start Time
- Specifies the recurring time at which the Batch Sync Setup job will run.
- Default: midnight
- Period (in minutes)
- Specifies how frequently, in minutes, the batch job is executed.
- Default: 1440 minutes (24 hours)
- Number of activation attempts
- Specifies the maximum number of attempts to activate synchronization for a prospect.
- Default: 5
- Days in Past (Initial Snapshot Properties section)
- Specifies how far back existing items should be snapped to and from Exchange (initial snapshot) when a user is newly configured for synchronization.
- Default: 0 days (hence, no existing items in the past are snapped)
- Days in Future (Initial Snapshot Properties section)
- Specifies how far into the future existing items should be snapped to and from Exchange (initial snapshot) when a user is newly configured for synchronization.
- Default: 0 days (hence, no existing items in the future are snapped)
- Click OK.